Medical

DATAMAX M 4206 MARK II DRIVERS FOR WINDOWS

39 mins ago



Page 74 A paper or synthetic printing material, typically with a pressure sensitive adhesive backing. Fault And Warning Messages 7. Indicates a top of form or mechanical error has occurred Solid On: Orders will be combined if nece Do not use your printer near water, or spill liquid into it.

Uploader: Zulurg
Date Added: 25 July 2017
File Size: 37.77 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 91909
Price: Free* [*Free Regsitration Required]

Page 65 System Settings continued When a fault condition ribbon out, media out, etc.

This page was last updated: It allows you to print numerous continuous forms, fanfold paper and perforated labels to suit your business requirements. This USB label printer comes with 8 MB printer memory for hassle-free printing with larger workloads.

Media Width Dtaamax 6. Page of Go. Indicates the printer is receiving data from the host STOP Lights will be on during power-up initialization and datamax m 4206 mark ii warm reset.

Datamax M-Class Mark II M 10 ips Monochrome Thermal Label Printer

Route the Media through the printer as shown. The numbers indicate the number of dots.

Embedded Fonts And Barcodes Embedded Fonts and Barcodes All character fonts and barcodes available with the printer are described in this section. Don’t show me this message again.

Print a Database Configuration label to ensure the new length has been set. Cleaning The Printhead 6.

Datamax M-Class Mark II M-4206 Operator’s Manual

Close the Printhead Assembly and press down until it locks into place. Printer When used with approved supplies: Page Barcodes Bar Code fonts have iii names left column in the table below.

Manual Media Sensor Calibration 4. Depending upon the type of Ribbon Supply Hub see 3. Printer Setup Menu List 4.

Datamax M-Class Mark II M Specs – CNET

Three different methods are available to calibrate the printer: Ensure the inked side of the ribbon faces the media and NOT the printhead. The power supply automatically detects and then adjusts to the applied line voltage; see Section 7.

Cleaning The Printhead Burn Line. Continue to hold the buttons down until the light turns off approximately 17 seconds.

Datamax M-Class Mark II M-4206 10 ips Monochrome Thermal Label Printer

Printer and cutter faults are disabled during If at any time you wish to discard your changes and revert back to dxtamax previous values, simply turn off power to datamax m 4206 mark ii printer. To save a manually entered setup for example, an application that required an Advanced Entry Calibration before beginning as a configuration file using the front panel: Advanced Entry Calibration 5.

Label advances inches before a fault indication The ribbon may be incorrectly installed.

Page If experiencing this problem… Try this solution… Examine the used ribbon for an image: The second label printed is the Dot Check Label. More Auto Media Sensor Calibration. Il addition, displayed sensor readings can be used to indicate the best position over the media, which is helpful when using small, position-critical TOF notches or marks. Other possible error messages are as follows Split ribbon datamax m 4206 mark ii hub.

The labels are incorrectly loaded: Limitation Of Liability Datamax hereunder by the purchaser for a defective product.