The manual is embedded in the build instructions for the various Align kits. This appears to come out of the manual. At least its identical to. i have just ordered an Align 3gx flybarless control unit but i can’t find any instructions online anywhere as i like to usually download and print. I have put together the written info on the Align 3GX v I found so far. Mostly for my own memory. I shrunk this info to a Pocket Guide that I will printout (or read.

Author: Mugal Dorn
Country: India
Language: English (Spanish)
Genre: Science
Published (Last): 3 August 2011
Pages: 122
PDF File Size: 8.86 Mb
ePub File Size: 17.35 Mb
ISBN: 734-4-72430-300-5
Downloads: 39278
Price: Free* [*Free Regsitration Required]
Uploader: Jutaxe

Align 3gx pdf manual | Model Flying

This completes the rudder endpoint limit adjustment for the right side. Tail pitch adjustment First check how the rudder responds to Tx.

Spektrum does make satellites but I am pretty sure they are not in any way compatible. Originally Posted by Tulo.

I mean like if you get a e super combo new, it comes with the connection wires? Trottle Calibration needs to be performed regardless. And yes you remove the bind plug while still powered, it sets fail safes, throttle etc. Check that there is no binding throughout the pitch range 3. To achieve consistent wlign gain on left and right, 3GX has built in anti-torque manula function. Subsequent setup mode is entered by a single press of the SET button.


REV begin to flash in sequence. Check that there is no binding throughout the pitch range 4. With all channels stationary, move the transmitter elevator stick forward, and then back to center position.

Are you sure you don’t remove the bind plug after powering down? Password Please enter a password for your user account.

Align 3GX version 2. Push the transmitter rudder stick left or right to select the frame rate. Graphical illustrated instruction on the computer setup software directs the user through a step by step setup process, allowing for quick setups without omitting mankal steps. Custom parameters have been opened up in 3GX to allow pilots to fine tune numerous settings for swashplate and rudder.

Originally Posted by bad What software, this software. The trim must be zero when using 3GX, and should not be adjusted at anytime. With built in pirouette compensation function, 3GX is able to stabilize the helicopter on a fixed point during pirouetting maneuvers. Value should be tuned under actual flight conditions by increasing to the maximum gain without tail hunting.

Press and hold the SET button while powering up the receiver. Tilt the helicopter right as shown in diagramand check if swashplate is tilting correctly toward the left. Gyro gain For radio with built manial gyro gain settings, gain can be adjusted directly.


Push bind button my spektrum tx module 4.

3GX Flybarless System – Introduction – Align

The result is a dramatic stability improvement from previous generation, with stability that rivals a flybarred helicopter, yet posses explosive agility. Are there pages missing? There is a direct correlation between servos’ speed to gyro’s performance. The recommended collective pitch range for various T-Rex helicopters is degress depending on preferenses. This setup mode sets the elevator gyro direction Tilt the helicopter forward and check if swashplate is tilting correctly aligm the back.

Align 3gx pdf manual

Please enter a valid email address for yourself. Actual gain value differs amongst servos and helicopters. It’s a must and to be used with the dongle via usb port on the PC. Aileron and elevator rates can be adjusted in 3GX panel or cyclic pitch rate adjustment under flight mode settings. Based on the 3G FL manual setup process, the 3GX can be setup in a few minutes through a simple process.

User need to confirm if 3GX is mounted right side up or upside down.