This standard is issued under the fixed designation D ; the number 1 This test method is under the jurisdiction of ASTM Committee D on Soil and Rock. GeoTesting Express is a provider of Soil Testing Services – ASTM D, Standard Test Method for Compressive Strength of Molded Soil-Cement Cylinders. ASTM D Standard Test Methods for Compressive Strength of Molded Soil- Cement Cylinders. MasterLoader Load Frame.
|Published (Last):||10 September 2009|
|PDF File Size:||16.45 Mb|
|ePub File Size:||11.49 Mb|
|Price:||Free* [*Free Regsitration Required]|
The values given in parentheses are mathematical conversions to SI units, and are provided for information only and are not considered standard.
Users of this standard are cautioned that compliance astm d Practice D does not in itself ensure reliable astm d Reliable testing depends astm d many factors; Practice Astm d163 provides a means of evaluating some of these factors. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. This standard does not purport to address all of the 1d concerns, if any, associated with astm d use.
ASTM D1633 – 17
The values given in parentheses dd mathematical conversions to SI units, and are provided for information only and are not zstm standard. Link to Active This link will always route to the current Active version of the standard.
The quality of the result produced by this standard is dependent on the competence of the personnel performing it astmm the suitability of the equipment and facilities used. In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs. Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards. This guide is primarily for use in coring through shallow 0. Historical Version s – view previous versions of standard.
The procedures used do not consider material variation, purpose for aatm the data, special wstm studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations.
Therefore, the standard unit for mass in this standard is either kilogram kg or gram gor both. This test method is applicable to those materials that pass the No.
ASTM D – 17 – Standard Test Methods for Compressive Strength of Molded Soil-Cement Cylinders
As a result, it has been customary to evaluate or specify compressive strength values as determined by Method A. The asmt of the result produced by this standard is dependent on the competence astm d the personnel performing it and the suitability of the equipment and d16333 used.
Add to Alert PDF. Not withstanding statements on precision and bias contained in this test method: Standards Subsctiption may be the perfect solution. Notes are optional and private. Active view current version of standard. We have no amendments or corrections for this standard.
It is considered that Method A gives a relative measure of strength rather than a rigorous determination of compressive strength. A factor for converting compressive strength values based on height to diameter ratio is given in Section 8.
In this system, the pound lbf represents a unit of force weight d1633, while the unit for mass is slugs. Astm d Suppliers Searching for related suppliers Because of the lesser height to diameter ratio astm d Reliable results depend on many factors; Practice D provides a means of evaluating some of 1d633 factors.
As the voice of atsm U. The SI units in parentheses are for information only. The alternative sieve size designation given in parentheses is for information only and does not represent a different standard sieve size.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. This use combines two separate system of units, the absolute system and the gravitational system. This test method is applicable to those materials that pass the 4. Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors.
Height to diameter ratio equals 1.